Hall-research UVB1-CP-S Bedienungsanleitung PDF herunterladen (Seite 3)

Com

onent Video Active Balun

3.0 Installation

1. Start by making sure that the power is off on your video source and the

monitor.

2. Find the “Sender” Balun and connect it using one

of the supplied 3-RCA cables to your video source

(e.g. DVD player or Satellite receiver).

3. Connect the Sender’s RJ45 port to the receiver

using straight-through

UTP or STP cable directly

to the Receiver. You cannot connect the Cat5

cable to any other manufacture’s device or

network equipment.

4. Connect the “Receiver” to the display device (e.g.

LCD TV or Projector). Make sure to match the

colors of the YPbPr cables to your display’s input

port.

5. Connect the supplied power adapter to the power

input connector on either of the units. Note that

only one power adapter is used to power both the

sender and receiver. It can be plugged into either

of them.

6. Power up the source and destination equipment and check for an

image.

4.0 Recommended Maximum Cable length

We recommend that you limit the length of the CAT5 cable as listed in the

table below based on the video signal resolution.

Exceeding the recommended cable lengths may degrade the video signal

depending on the resolution and the cable type used.

Max Distance

480i or 576i 1000 ft

480p or 576p 750 ft

720p, or 1080i 500 ft

Resolution

1080p 300 ft

Table 4.1

1 2 3 4

Keine Kommentare

Hall-research UVB1-CP-S Bedienungsanleitung Seite 3