Hall-research UVA-16X Bedienungsanleitung PDF herunterladen (Seite 7)

UV-16 Family of Mini-Cat

Senders

2. Installation

1. Connect the video source to the PC/HDTV connectors. For Model

UVA-16X, connect the audio source to the AUDIO connectors.

2. Connect the included power cord to the power input connector on

the unit.

3. Using Category-5 or higher UTP cable, connect one or more

compatible receivers to the sender’s RJ45 outputs.

4. Connect the remote display/projector and possibly the speakers to

the receiver unit.

If using the Model UV1-S-16X, the receivers can be powered from

the CAT5 cabling if desired and the cables are less than 500 feet

from the sending unit.

CAUTION

Before plugging in the remote monitor, verify that the AC line is properly

wired and that a protective ground (green) wire is established with NO

potential difference between both the sender and receiver locations. The

splitter can tolerate up to 5 v peak-to-peak ground potential between the

two locations. Failure to ensure good grounding can result in erratic

operation and possible shock hazards or damage to your equipment.

NOTICE

Do not connect this unit to any LAN device such as network cards or hubs

as this may damage the UVA/URA and/or the LAN device. Use EIA/TIA 568B

standard straight-through patch wiring as shown below. Do not use

crossover cables.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Keine Kommentare

Hall-research UVA-16X Bedienungsanleitung Seite 7